Foxwell NT680 Series

I’m going to show how to use Foxwell NT680 Pro Scanner to reset the check engine light for a BMW 3 series. As you can see, there is a warning light on the dashboard. Connect NT680 Pro with BMW OBD, press Diagnostic >> Europe >> BMW >> Manual Selection >> 3 Series >> F30/F31/F35 Turn off the ignition. Wait for approx 10s... Turn on the ignition again. Diagnosis >> Control modules >> Drive >> Engine - DDE diesel electronics >> Read codes  It got 2 fault codes: 25F500 - Intake air temperature sensor, signal: open or short circuit to B+ 28D600 - Hot film air mass meter, signal interruption or short circuit to ground or positive terminal. After working out there was a problem with the mass airflow sensor on BMW which I’ve now replaced actually. But the BMW still got a check engine light and the fault codes.  It is normal, what I need to do is go to “Clear Codes”. Codes cleared! Look, check engine light disappeared meanwhile. Do...

The BMW 3 series has an ABS and traction warning light on the dashboard, so I’m gonna show how to reset it with the Foxwell NT680 Pro Scan Tool . Plug connector into OBD2 port, press Diagnostic >> Europe >> BMW >> Manual selection >> 3 series >> F30/F31/F35 Turn off the ignition. Wait for approx 10s... Switch on the ignition again. Diagnosis >> Control modules >> Chassis >> ABS-DSC dynamic stability control >> Read codes It tells about one fault code: 48082A - Wheel speed sensor: voltage supply, short circuit to B+. rear right. The information means the rear right ABS sensor or wheel speed sensor is actually faulty, which needs to be replaced. Having been replaced with a new sensor, let’s go back to  Clear codes >> Codes cleared, OK Now you can see, the warning lights on the dashboard have gone! BMW ABS/DSC warning light reset is successful. This is using Foxwell NT680 Pro Scanner to get rid of the warning lights for a BM...